Table of Contents
Advertisement
8.7
Alternate cycle time selection
The alternating cycle times can be selected to provide an individualised care program
for each patient.
Within Alternating mode the alternating cycle time can be selected by pressing the
Cycle button. Selections can be made from 10-30 minutes at 5 minute intervals. The
cycle time will be displayed in the LCD screen.
8.8
Alarm mute
The Alarm Mute button temporarily resets the audible Low Pressure/Power
Failure/Service alarms. Should the situation not be resolved and the fault condition
continues the alarm will resume notifying carer.
9. CPR Mode
Pull out and
rotate for CPR
10. Transport Mode
Issue 9 – 15/09/2022
CPR (Cardio Pulmonary Resuscitation) can be performed using the
red CPR valve which is situated at the head end on the left hand
side of the mattress.
For rapid deflation gently pull and rotate the dial of the CPR valve
to 'click' into the OPEN position. At the same time, disconnect the
air pipe connector from the power unit to speed up the air release.
If re-inflating the mattress, ensure the dial of the CPR attachment
is rotated until it 'clicks' into the CLOSED position.
If the patient is being moved on the mattress, or there is a power
cut, general pressure can be maintained in the system for an
adequate period of time whilst disconnected from the mains.
Simply disconnect air pipe connector and place the connector
cover over it. The air pressures in the mattress will remain as they
were, but will maintain a degree of comfort. This will maintain the
cells in their present state for up to 24 hours.
It is important to restore the Tamora Plus II Digital dynamic
replacement mattress as quickly as possible by reconnecting the
supply tubes to the power unit.
Page 15 of 28
Advertisement
Table of Contents
