Table of Contents
Advertisement
8.6
Auto-Firm
Auto-Firm mode can be selected by pressing the Auto-Firm button. In this mode all
cells inflate to a single pressure setting to provide a firm and stable surface for nursing
procedures or for patient ingress/egress. The system will automatically return to
Alternating mode at the previously selected comfort level after 20 minutes.
8.7
Alternate cycle time selection
The alternating cycle times can be selected to provide an individualised care program for
each patient.
This mode is also for use for the cycle time of the turning when activated.
Within Alternating mode the alternating cycle time can be selected by pressing the
Cycle button. Selections can be made from 10-30 minutes at 5 minute intervals. The
cycle time will be displayed in the LCD screen.
8.8
Alarm mute
The Alarm Mute button temporarily resets the audible Low Pressure/Power
Failure/Service alarms. Should the situation not be resolved and the fault condition
continues the alarm will resume notifying carer.
9. CPR Mode
Pull out and
rotate for CPR
Issue 5 – 16/12/2020
CPR (Cardio Pulmonary Resuscitation) can be performed using
the red CPR valve which is situated at the head end on the left
hand side of the mattress.
For rapid deflation gently pull and rotate the dial of the CPR valve
to 'click' into the OPEN position. At the same time, disconnect
the air pipe connector from the power unit to speed up the air
release.
If re-inflating the mattress, ensure the dial of the CPR attachment
is rotated until it 'clicks' into the CLOSED position.
Page 14 of 28
Advertisement
Table of Contents
