Table of Contents
Advertisement
8
Warning: Any pull
on' ,,
the cable assembly
cause the cable to
become loose or come
off. If the cable
assembly is damaged,
the disk enclosure
assembly must be
replaced.
Disconnect the cable
from the servo card and
place the
cabl~
over the
actuator as shown.
9
Remove the specified
servo card from the
driver hoard.
Notes:
1. The unit reference code
identifies the specific
location of the serv<>
card to be installed.
2. Ta loosen and remove
the servo card, pull up
about 2 centimeters(O:&
inch) on the rear of the
card, then pull up 9w
the front ofthe card;'
AOC1 Servo Card
AOC2 Servo Card
RD18018-0
AOC1 Servo Card
AOC2 Servo Card
RD18035-0
2-33
Advertisement
Table of Contents
