Expansion Port Configuration - Fem Panel - IBM 8237 Installation And User Manual

Operational
This field displays the operating status of the MEP. Possible values are
YES and NO. YES indicates that the MEP is operating. NO indicates
that either the MEP has been disabled, or the MEP has been configured
as part of a backup pair and is currently not operating.
If an FEM is installed, the panel illustrated in Figure 3-18 will be displayed.
Hub ID : 1
Port ID : EP
Name :
Admin Status : ENABLED
Duplex Mode : AUTO NEGOTIATION
Duplex In Use : NEGOTIATED HALF-DUPLEX
Back Pressure : ENABLED
Forwarding Mode : ADAPTIVE CUT-THROUGH
Forwarding In Use : ADAPTIVE CUT-THROUGH
Use arrow keys to move. <Enter> to confirm.
Figure 3-18. Expansion Port Configuration - FEM Panel
Return to Previous Panel
Return to the Port Configuration: Port Selection panel.
Hub ID
This field displays the hub ID number.
Position
This field displays the 8237's position in the stack in top-down order.
Port ID
This field displays the type of port. This value is always EP for the
Expansion Port.
Name
This field is where you can assign a meaningful name to the FEM port.
Type
This field displays the type of FEM. Possible values are 10BASE-T/
100BASE-TX, and 100BASE-FX.
Speed
This field displays the FEM's speed. Possible values are 10M and 100M.
Link Status
This field displays the FEM's current status. Possible values are UP and
DOWN.
Admin Status
This is a selection field. Possible values are ENABLED and DISABLED.
Expansion Port Configuration - FEM
Return to Previous Panel
<Ctrl+T> to return to Main Menu.
Position :
Type : 10BASET/100BASETX
Speed : 10M
Link State : DOWN
Operational : YES
Chapter 3. 8237 Administration
1
3-23