Simm Removal; Simm Replacement - IBM 8237 Installation And User Manual

7
Figure 4-10. SIMM Removal
Figure 4-11. SIMM Replacement
8
9
4-12
8237 Hub Installation and Planning Guide
New or replacement RMON Daughter Boards do not include a memory SIMM.
To transfer any installed SIMM to the new RMON Daughter Board:
• Disconnect the old SIMM from the RMON Daughter Board by compressing
the clip on each side of the SIMM, moving the top of the SIMM to a vertical
position and then lifting the SIMM up and out of its slot, as shown. See
Figure 4-10.
• Install the new SIMM by sliding it into the slot and rotating the top to the
back, as shown. See Figure 4-11. Make sure that the clips snap into
place.
Replace the cover by reversing the actions in step 2. Note that both sides of the
top cover fit inside the edges of the bottom cover.
Connect ac power by attaching the power cord to the 8237 and then to the ac
outlet.