Table of Contents
Advertisement
CS170-Q370/C246/H310
► Advanced
Power & Performance
Configure the power and performance settings in this page.
Intel(R) SpeedStep(tm)
Enable or disable Intel Enhanced SpeedStep Technology. Voltage and frequency are switched
between high and low levels in response to processor load when this field is enabled, and the
Turbo Mode field will appear.
Turbo Mode
Enable or disable processor turbo mode, which allows the processor core to automatically run
faster than the base frequency when the processor's power, temperature, and specification are
within the limits of TDP. This field is only available when "Intel(R) SpeedStep(tm)" is enabled.
C states
Enable or disable CPU Power Management. When enabled, the CPU is allowed to go to C
states when it's not 100% utilized.
Chapter 3 - BIOS Settings
► Advanced
PCH-FW Configuration
Configure the parameters of Management Engine Technology.
ME State
Enable or disable Management Engine. When this field is set to Disabled, ME will be put into
ME Temporarily Disabled Mode. The following fields will only appear when ME State is enabled.
Manageability Features State
Enable or disable Intel(R) Manageability features. This option disables/enables Manageability
Features support in FW. To disable, support platform must be in an unprovisioned state first.
AMT BIOS Features
When disabled, AMT BIOS features are no longer supported and user is no longer able to ac-
cess MEBx Setup. This option does not disable manageability features in FW.
► AMT Configuration
This section is used to configure Intel(R) Active Management Technology Parameters. Please
refer to the following pages.
ME Unconfig on RTC Clear
When disabled, ME will not be unconfigured on RTC Clear.
► Firmware Update Configuration
Please refer to the following pages.
34
www.dfi.com
Advertisement
Table of Contents
