Troubleshooting - Zephyr elica Glide Use, Care And Installation Manual

issue Cause What to do
After installation, the
unit doesn't work?
1. The power source is not turned ON.
1.
2. The power line and the cable locking 2.
connector is not connecting properly.
3. The switch board and control board 3.
wirings are disconnected.
4. 4.
Make sure the circuit breaker and the
unit's power is ON.
Check the power connection with the
unit is connected properly.
Make sure the wirings between the
switch board and control board are
connected properly.
Change the switch board or control
board.
Change the motor. Light works, but motor is 1. 1.
not turning.
2. 2. The motor will function properly after the
thermally protected system cool down.
The switch board or control board is
defective.
The motor is defective, possible
seized.
The thermally protected system
detects if the motor is too hot to
operate and shuts the motor down.
Damaged condenser.
The motor is not secure in place.
Damaged blower wheel.
The hood is not secured in place.
Defective halogen bulb.
The light bulb is loose.
The hood might be hanging to high
from the cook top.
The wind from the opened windows or
opened doors in the surrounding area
are affecting the ventilation of the
hood.
3.
The unit is vibrating. 1.
2.
3.
The motor is working, 1.
but the lights are not.
2.
1.
2.
3. Blocking in the duct opening or
ductwork.
The direction of duct opening is
against the wind.
4.
5. Using the wrong size of ducting.
The hood is not venting
out properly.
3. Change the condenser.
1. Tighten the motor in place.
2. Change the blower wheel.
3. Check the installation of the hood.
1. Change the halogen bulb.
2. Tighten the light bulb.
1. Adjust the distance between the cook
top and the bottom of the hood within
24" and 32" range.
2. Close all the windows and doors to
eliminate the outside wind flow.
3.
Remove all the blocking from the duct
work or duct opening.
4. Adjust the duct opening direction.
5. Change the ducting to at least 8" or
higher.
Metal filter is vibrating. 1. Metal filter is loose. 1. Change the metal filter.
C
iim
O
O
m
O
@