Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zephyr Elica Concave ECO-M90AS
Summary of Contents for Zephyr Elica Concave ECO-M90AS
- Page 1 JAN06.0101...
- Page 2 GB page F page E page APPROVED FOR RESIDENTIAL APPLIANCES FOR RESIDENTIAL USE ONLY READ AND SAVE THESE INSTRUCTIONS PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTANT: Save these Instructions for the Local Electrical Inspector’s use. INSTALLER: Please leave these Instructions with this unit for the owner.
-
Page 3: Table Of Contents
www.zephyronline.com Important safety Notice ..............4 Electrical & Installation requirements ..........5 Electrical requirements .............. 5 Before installing the hood ............5 List of Materials ................. 6 Parts supplied: ................6 Parts not supplied ..............6 Dimensions and clearances .............7 Installation Instructions ..............8 Venting methods ................ - Page 4 READ AND SAVE THESE INSTRUCTIONS CAUTION: FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPORS. WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. B.
-
Page 5: Electrical Requirements
www.zephyronline.com ELECTRICAL REQUIREMENTS Important: Observe all governing codes and ordinances. It is the customer’s responsibility: • To contact a qualified electrical installer. • To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 —... -
Page 6: Parts Supplied
PARTS SUPPLIED: • Blower unit housing • Hood canopy • Metal filter x 1 • Halogen light bulb x 2 • Duct covers • Decorative panel • Hardware Packet: Allen spanner x 1 Remote Control Cloth Duct cover support bracket Lower duct cover bracket Lower support bracket Template... - Page 7 www.zephyronline.com 17" 8/16 15" 13/16 max 53" 8/16* min 35" 5/16* max 51" 4/16 min 35" 5/16 35" 5/16 30" 5/16 1" 15/16 35" 6/16 21" 3/16 Ø 13" 3/8 8" 7/16 1" 7/8 4" 2/8* ceiling Ducting and conduit 3"...
-
Page 8: Venting Methods
Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. VENTING METHODS The hood is equipped with a transition B for discharge of fumes to the outside (Ducting version). Should it not be possible to discharge cooking fumes and vapour to the outside, the hood can be used in the Ductless (recirculating) version. - Page 9 www.zephyronline.com Duct pieces Equivalent number Duct pieces Equivalent number lenght x used Total lenght x used Total 3 1/4 ” x 10” 1 Ft. 6" Round 30 Ft. x ( Rect., wall cap straight with damper 6 ” Round,, 1 Ft. 6”...
- Page 10 6. Mark wall with horizontal line 1" above highest and 1. If possible, disconnect and move freestanding or 1" below lowest fastener location. slide-in range from cabinet opening to provide easier access to rear wall. Otherwise put a thick, protective 7.
- Page 11 www.zephyronline.com 14. Canopy and blower unit housing are assembled 15. Hang the blower unit housing with the 2 for shipping, these must be divided: mounting hooks. a. Put the canopy and the Blower unit housing assembly on a flat surface, remove the grease filter WARNING (see also Care &...
-
Page 12: 19. Electrical Connection
19. Electrical connection Conduit WARNING Electrical Shock Hazard Warning: Turn off power circuit at the service panel before wiring this unit. 120 VAC, 15 or 20 Amp circuit required. J-Box cover ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE. - Page 13 www.zephyronline.com 20. Final assembly of the duct covers (canopy): 21. Fit control ball with its molex plug on its housing Lower section of the duct cover serves to hang the and twist in place. decorative panel. Use pins (2 upper + fixing screws and 1 at the bottom) to fix the decorative panel.
-
Page 14: Control Ball
22. Assemble the duct covers (canopy) with the integral b. Make all cable connections: ventilator housing. WARNING Excessive Weight Hazard Use two or more people to move and install range hood. Failure to do so can result in back or other injury. a. - Page 15 www.zephyronline.com 23. Fix the lower duct cover bracket with two screws, so that the bracket blocks the lower duct to the wall. 24. For Ductless (recirculating) installations Install one charcoal filter (available as an extra kit). 25. Install filters. 26. Install upper duct cover to its upper support with 2 screws (1 per side).
- Page 16 1 Control panel 2 Grease filter 3 Grease filter release handle 4 Halogen lamp (position and nr. of lamps may vary) 5 Vapour screen 6 Duct cover 7 Air outlet (used for Ductless version only)
- Page 17 www.zephyronline.com CONTROLS Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approxi- mately after terminating cooking.
-
Page 18: Remote Control
USING THE REMOTE CONTROL This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The remote control may operate in humid environments, but not when placed on wet surfaces. -
Page 19: Cleaning
www.zephyronline.com Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply. CLEANING The cooker hood should be cleaned regularly internally and externally. For cleaning use the supplied cloth moistened with a neutral liquid detergents. Avoid abrasive detergents. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. - Page 20 Issue Cause What to do After installation, the 1. The power source is not turned ON. 1. Make sure the circuit breaker and the unit doesn’t work? unit’s power is ON. 2. The power line and the cable locking 2. Check the power connection with the connector is not connecting properly.
-
Page 21: Warranty
When product is used commercially or other than its intended purpose. Damaged because of improper connection with equipment of other manufacturers. Repaired or modified by anyone other than Zephyr’s Authorized Agents. What is Not Covered: Consumable parts such as light bulbs, filters, and fuses. Services outside of service area and the labor cost incurred in connection with the removal, shipping and reinstallation cost, nor does it cover any other contingent expenses. - Page 22 Part Description Part# Z0B-0009 halogen bulb, 12V 20 W metal filter GF02IA 2009C remote control (RF) Part Description Part# ZRC-00CS Ductless conversion kit Z0F-C060 charcoal replacement filter duct cover extension kit internal blower - 600 cfm EBI-600A in-line blower - 1100 cfm EBN-1100A...
- Page 23 www.zephyronline.com...