Replace Fan Assembly - Graco 273199 Repair Parts

Repair

Replace Fan Assembly

1. Follow the Prepare the Motor for Repair procedure
on page 8.
2. Remove the two screws (6) and washers (7). Remove
the junction box cover (5) from the motor (A) to gain
access to the disconnect block (DB).
A
5
7
6
3. Loosen the screws for 1L1 and 5L3 and gently
remove the wires from each location.
4. Use a wire cutter to cut the ferrule tips from the fan
wires and cut the motor power wires close to the
ferrules.
NOTE: Do not cut the tip off of the ground wire (GW).
10
5. Remove the grounding screw (GS) and disconnect
the green grounding wire coming out of the fan cord
grip (C1) attached to the motor (A), not the junction
box.
C1
6. Loosen the fan cord grip (C1) attached to the motor
(A) and pull out the fan wires.
7. Remove the screws that attach the fan assembly (FA)
to the motor (A). Pull up on the end farthest from the
junction box. Slide the assembly toward the junction
box to remove the fan assembly.
A
GW
GS
C1
FA
3A7940A