Table of Contents
Advertisement
RJ45
CONNECTOR
Figure 22: Location of the RJ45 connector on the electronic control board
6.4 CELLULAR
The charging station needs to be installed in a location with a strong cellular signal. You can check the
signal strength using a cell. Check if you have full bars on the device. The higher the level, the better
the cellular network signal. They will indicate if the signal of the cellular network is good in the
environment chosen.
The charging station has an external high-gain antenna and is compatible with LTE Cat M1 and NB
IoT mobile networks, allowing the use of a SIM card with a data plan to connect the station when it is
out of range of a Wi-Fi network or a wired Ethernet (RJ45) network.
NOTE!
This product works exclusively with SIM card in nano size (12.3 mm high × 8.8 mm wide). When
hiring a data plan with a telephone operator, be aware of this detail.
ATTENTION!
Make sure the station is turned off before inserting or removing the SIM card. Otherwise, the
station and/or SIM card may be damaged.
To install the charging station SIM card, follow the instructions below:
1.
Open the charging station front door;
2. Find the SIM card slot in the central right part of the electronic control card;
Connectivity
WEMOB-STATION | 33
Advertisement
Table of Contents
