Corrective Maintenance; Positioning - WEG WEMOB-STATION-CCS-30kW Series Installation And Operation Manual

Table of Contents

Advertisement

Installing and Connecting

3.2.3 Corrective Maintenance

Every fault or abnormality observed in the electrical equipment in operation must be communicated to
qualified personnel for the proper repair.
That must be done especially when the protection devices actuate without any known reason.
When the protection circuit breaker trips, identify and solve the cause before turning the equipment back
on.
If the WEMOB-STATION is defective, contact WEG Technical Support on the phone 0800-7010701 or e-
mail 0800@weg.net.

3.2.4 Positioning

A minimum space of 0.4 meters must be provided around the entire station (above, below and on the sides)
to allow good air circulation and better heat dissipation, in addition to the circulation of users.
In order to prevent overheating, the ventilation openings must not be blocked.
Figure 8: Minimum recommended clearance in inches and mm - [ " ] mm
ATTENTION!
The position of the WEMOB-STATION must allow the necessary ventilation flow for its
operation.
18 | WEMOB-STATION

Advertisement

Table of Contents
loading

This manual is also suitable for:

Station ccs-2 30 kw

Table of Contents