Table of Contents
Advertisement
3 INSTALLING AND CONNECTING
This chapter describes the mechanical and electrical installation procedures for the WEMOB-STATION.
The directions and suggestions must be observed in order to ensure the safety of people and equipment
and its proper operation.
3.1 RECOMMENDED HANDLING PROCEDURE
It is recommended to completely remove the packaging only after positioning the WEMOB-STATION
charging station in the final place of operation. Before lifting or moving the charging station, read the
instructions below to learn about the available points for mechanical connection of lifting equipment,
transportation and weak points.
3.1.1 Handling
If using a crane or hoist, make sure that the movements are slow and smooth so that the WEMOB-STATION
will not suffer excessive swing or vibrations.
When using hydraulic carts, forklifts, rollers or other handling equipment, distribute the mechanical support
points of such equipment from one end of the WEMOB-STATION to the other, avoiding applying pressure
on fragile areas. If the packaging has already been removed, make sure that all WEMOB-STATION walls
are closed
-
Forklift.
-
Hoist with lifting beam.
ATTENTION!
The use of chain under the box for lifting and handling is prohibited.
3.1.2 Opening the Package
Use suitable tools to unpack the WEMOB-STATION, always taking care not to damage the equipment.
While opening the package, check if there are damages to the product. Do not install the WEMOB-
STATION charging station in case you suspect any damage.
Remove any particles from the package (plastic, wood, styrofoam, metal, nails, screws, nuts etc.) that may
have remained in the charging station.
Figure 6: Procedure for handling with forklift or hoist
Installing and Connecting
Merely illustrative image
WEMOB-STATION | 13
Advertisement
Table of Contents
