Table of Contents
Advertisement
Connectivity
You can change the Wi-Fi connection and connect the station to another network in two ways: via the
station current IP or by resetting the Wi-Fi settings.
Repeat procedures 5 and 6. In procedure 5, use the current IP address of the charging station. To that end,
it is necessary to know the IP address of the station, for example: 192.168.100.55.
6.2 WI-FI NETWORK
The charging station needs to be installed in a location with a good level of Wi-Fi signal. If necessary, install
repeaters or a wireless "access point" (the router connects to another router via cable, and the second
device acts as a repeater). You can check the Wi-Fi network signal strength using a smartphone or another
device, checking if you have full bars on the device. The higher the level, the better the Wi-Fi network signal.
They will indicate if the Wi-Fi signal is good in the chosen environment. The charging station has an external
antenna to better capture the Wi-Fi network signal.
If it is the first configuration of the station on the Wi-Fi network, the station generates an "access point", a
Wi-Fi network identified as WEG-EVSE-xxx, so that another device (smartphone, tablet, computer etc.) can
access the station Wi-Fi network settings.
NOTE!
The charging station connects only to Wi-Fi networks IEEE 802.11 b/g/n, 2.4 GHz, with
WPA2/WPA Personal security protocols, which are networks that only require access
password without the need for user and password;
If the registered Wi-Fi network is not available during energization or during operation of
the charging station, it will automatically reconnect as soon as the Wi-Fi network is
available again.
6.3 ETHERNET
NOTE!
Some models of charging stations have an RJ45 connector at the bottom for connection
to the Ethernet network. Check if the purchased station model has this conector;
The charging stations are not prepared to work in networks that require user and
password authentication (proxy).
The RJ45 connector follows the Fast Ethernet 100BASE-TX standard, using two pairs of cables for data
transmission and reception. Connect the cable from the router to the charging station at the RJ45 port. Use
standard Ethernet cable, 100 Base-TX (Fast Ethernet), CAT 5e or higher, with a maximum length of 100
m. To avoid interference in communication, the power cables must be separated, as far as possible, from
the ethernet communication cable. Pass the RJ45 ethernet cable through the duct located at the base of
the station through the metal structure to the RJ45 connector available on the electronic control board.
32 | WEMOB-STATION
Advertisement
Table of Contents
