Messages In The Display - Miele TWL 780 WP Operating Instructions Manual

Problem solving guide

Messages in the display

Message
000
Finish/Cooling down

Clean the plinth filter.
See 

Fill condensate
container

Open & close door
 Please wait
66
Possible cause and remedy
Access via a code has been activated.
 Enter the code and confirm the entry. Deactivate
the code if you do not wish this message to
appear in the display the next time the machine is
switched on.
The laundry is cooled down at the end of the
programme.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
The tumble dryer is not working correctly or
economically. Possible causes could be clogging
caused by fluff or detergent residues.
 To deactivate the message, confirm with
 Please see "Cleaning and care" for notes on
cleaning.
 Clean the fluff filters.
 Also check the plinth filter and clean it if
necessary.
You can influence when the
 message lights up.
 Follow the instructions in "Settings - Airways
indicator".
The condensed water container is empty. When
certain programmes are being used, water is taken
from the condensed water container and recycled.
 Fill the condensed water container to at least the
―min― mark.
 To deactivate the message: confirm with OK.
This is to remind you to load the laundry when the
programme is selected.
 Load the laundry in the drum.
The tumble dryer is expecting to receive programme
data from the washing machine (Wash2Dry), or
SmartStart is activated.
OK
Clean the plinth filter. See
.