Problem solving guide
Many malfunctions and minor faults that can occur in daily operation can be
corrected without contacting Miele. This will save you time and money because
you will not need a service call.
You can find information on how to remedy faults yourself at
www.miele.com.au/service or www.miele.co.nz/service.
Please note, however, that a call-out charge will be applied to unnecessary service
visits where the problem could have been rectified as described in these operating
instructions.
Some of the messages in the display are more than one line long. Touch the or
sensor to read them in full.
Fault messages shown in the display when a programme is
cancelled
Message
Empty container.
See
Blockage detected.
See
Service Fault F
XXX
64
Possible cause and remedy
The condensed water container is full or there is a
kink in the drain hose.
To clear the message, open and close the door
with the tumble dryer switched on. Or switch the
tumble dryer off and then on again.
Empty the condensed water container.
Check the drain hose.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. If
necessary, take out some of the laundry.
Switch the dryer off and back on.
Start a programme.
There is no obvious cause.
Switch the dryer off and back on.
Start a programme.
If the programme terminates again with the same
fault message, then there is a fault. Contact Miele.