Hardware Setup - ProfiTap ProfiShark 100M User Manual

2.3. Hardware Setup

Connect the line to be monitored to the ProfiShark's network ports.
Connect the ProfiShark to the computer using the supplied USB 3.0 cable.
Note: Connecting to a USB port of specification lower than USB 3.0 may result in data drops, due to
bandwidth limitations.
ProfiShark 1G / 1G+
When deploying ProfiShark 1G/1G+ in-line, connect it to the network prior to powering it in order to make
full use of its fail-safe capabilities. This step is critical to verify the availability of the in-line path in case of
failover.
(Optional) Connect a dedicated power supply to the ProfiShark 1G/1G+ to ensure maximum fail-safe
operation at all times. In the absence of a dedicated power supply, the ProfiShark 1G/1G+ is powered
through the USB 3.0 cable.
(Optional) Connect the GPS antenna to the ProfiShark 1G+ in order to benefit from GPS-linked timestamp
synchronization. Position the antenna outside or near a window for the best results.
ProfiShark 10G / 10G+
If fiber SFP/SFP+ modules are used, make sure to match the Tx-Rx / Tx-Rx signal direction at the other
end.
If copper SFP/SFP+ modules are used, connect either the supplied USB to DC power cable or a
compatible 5V/1.5A power supply to the ProfiShark 10G/10G+, to ensure the required power is being
supplied to the unit. In the absence of an additional power connection, the ProfiShark 10G/10G+ is
powered through the USB 3.0 port alone and can only sustain fiber optic SFP/SFP+ modules.
(Optional) Connect the GPS antenna to the ProfiShark 10G+ in order to benefit from GPS-linked timestamp
synchronization. Position the antenna outside or near a window for the best results.
Note: Due to the nature of SFP modules requiring power for operation, ProfiShark 10G/10G+ doesn't
include a bypass feature for fail-safe monitoring. An external TAP can be employed in order to implement
fail-safe monitoring.
28