Ebyte E95-DTU 433C 485-V2 Series Manual page 6

Chengdu Ebyte Electronic Technology Co.,Ltd.
Start two serial port debugging assistants, select the serial port baud rate of 9600bps (default), the
4
parity mode is 8N1, you can realize the serial port transmitting.；
If the customer needs to switch the working mode, it can be controlled by Mode button to switch different
working modes (M0 indicator, M1 indicator). Long press the Mode button once for 1ms and then release it to
switch the mode once, the details of mode switching are shown in the following table.
Mode Type
Continuo
Mode 0
us mode
General
Mode 1
mode
Configur
Mode 2 ation
Mode
reserved
Mode 3
mode
Note: The radio has the function of power-down saving mode (factory default setting is transmissive mode),
users need to switch the corresponding mode according to M1, M0 indicator (effective immediately).
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
M1 M0
The radio will automatically calculate
the required over-the-air transmission
rate
Lights Lights
transmission
out. out.
user-configured serial port baud rate
internally, and the user can just pass
in the data uninterruptedly.
The radio internally enforces the
Lights lights
user-configured
transmission rate. It will transmit in
out. on
packets at 55 bytes per packet.
The user can access the registers
lights Lights
through the serial port to control the
on out.
working status of the radio.
lights lights
The radio will not do any transmitting
or receiving in this mode.
on on
Notes
for continuous uninterrupted
according to
over-the-air
E95-DTU(433Cxx-485)-V2.0 User manual
Remarks
Supports
the
uninterrupted transmission
General Transparent
Transmission
Requires configuration
baud rate 9600
continuous
at
6