Page 3
E95-DTU(900SLxx-485) User Manual Disclaimer and Copyright Notice EBYTE reserves all rights to this document and the information contained herein. Products, names, logos and designs described herein may in whole or in part be subject to intellectual property rights. Reproduction, use, modification or disclosure to third parties of this document or any part thereof without the express permission of EBYTE is strictly prohibited.
1.Product Overview 1.1 Product introduction E95-DTU (900SLxx-485) is a wireless data transmission radio using military-grade LoRa modulation technology. It has a variety of transmission methods and works in the (850.125MHz ~ 930.125MHz) frequency band (default 868.125MHz). The radio provides transparent RS485/RS232 interface , Using plastic shell, rail type installation structure, support 8 ~ 28V (DC) voltage input.
1.3 Quick start You need to prepare two E95-DTU (900SLxx-485) First, install the antenna for the digital radio, and then install the power supply. The user can choose the power adapter to supply power according to their needs.
Chengdu Ebyte Electronic Technology Co.,Ltd. E95-DTU(900SLxx-485) User Manual 2.2 Communication interface description The E95-DTU (900SLxx-485) can be connected to the device through RS485 using the terminal block. standard number function explanation definition signal ground Anti-interference, grounding The RS485 interface A interface is connected to...
Chengdu Ebyte Electronic Technology Co.,Ltd. E95-DTU(900SLxx-485) User Manual 4.Detailed function 4.1 Fixed-point emission (hexadecimal) 4.2 Broadcast transmission (hexadecimal) 4.3 broadcast address Example: Set the address of radio A to 0xFFFF and the channel to 0x04. When station A is used as a transmitter (same mode, transparent transmission mode), all receiving stations under the 0x04 channel can receive data to achieve the purpose of broadcasting.
5.Operating mode E95-DTU has four working modes. When there is no strict low power consumption requirement, and normal communication is required, it is recommended to configure the radio in the transparent transmission mode (mode 0);The default setting of the radio is transparent transmission mode (mode 0).
Chengdu Ebyte Electronic Technology Co.,Ltd. E95-DTU(900SLxx-485) User Manual 6.Register read and write control 6.1 Instruction format In configuration mode (mode 2: the M1 indicator is on, the M0 indicator is off), the list of supported commands is as follows (when setting, only 9600 and 8N1 formats are supported)::...
Chengdu Ebyte Electronic Technology Co.,Ltd. E95-DTU(900SLxx-485) User Manual 7.Use of relay networking mode Number Relay Mode Description After setting the relay mode through the configuration mode, switch to the general mode, and the relay starts to work. In relay mode, ADDH and ADDL are no longer used as the radio address, but are forwarded and paired corresponding to the NETID respectively.
E95-DTU(900SLxx-485) User Manual 8.Host computer configuration instructions The figure below shows the E95-DTU (900SLxx-485) configuration host computer display interface, the user can switch to the configuration mode through the MODE button, and quickly configure and read parameters on the host computer.
E95-DTU(900SLxx-485) User Manual 12.Practical application areas Ebyte digital radio is suitable for all kinds of point-to-point, point-to-multipoint wireless data transmission systems, such as smart home, Internet of Things transformation, power load monitoring, distribution network automation, hydrology and hydrological forecasting, water pipe network monitoring, urban street lights Monitoring, air defense...
100mV. 14.Important Notice Ebyte reserves the right of final interpretation and modification of all contents in this manual. Due to the continuous improvement of the hardware and software of the product, this manual may be changed without prior notice, and the latest version of the manual shall prevail.