Unigas HTP2000 Installation Manual page 6

PART I: SPECIFICATIONS
Burner model identification
Burner8s are identified by burner type and model. Burner model identification is described as foll
Type HTP2000
(1)
1 BURNER TYPE
2 FUEL
3 OPERATION (Available versions)
4 BLAST TUBE
5 DESTINATION COUNTRY
6 BURNER VERSION
7 EQUIPMENT
8 GAS CONNECTION
8 MICRO-PROCESSOR CONTROL
Technical Specifications
Output
Fuel
Category
Gas rate min.-max.
Pressure
Light oil rate
Вязкость
Oil density
Oil train inlet pressure
Power supply
Total power consumption
Электродвигатель вентилятора
Protection
Operation
Gas train 80
100
125
Operating temperature
Storage Temperature
Working service
Note1:
All gas flow rates are referred to Stm
(net calorific value H
Note2: Maximum gas pressure = 500mbar (with Siemens VGD)
Minimum gas pressure = see gas curves.
Note3: Burners are suitable only for indoor operation with a maximum relative humidity of 80%
Model MG. MD. S.
(2) (3) (4)
3
/h (1013 mbar absolute pressure, 15 °C temperature) and are valid for G20 gas
3
= 34.02 MJ/Stm );
i
*. Y. 8. 80.
(5) (6) (7) (8)
HTP2000
G - Light oil
M - Natural gas
MD - Fully modulating
S - Standard
* - see data plate
A - Standard
Y - Special
1 = 2 gas valves + gas proving system
8 = 2 gas valves + gas proving system + maximum gas pressure switch
80 = DN80 100 = DN100
ES = with no O trim control, with no VSD control
2
EO = with O trim control, with no VSD control
2
EI = with no O trim control, with VSD control
2
EK = with O trim control, with VSD control
2
min. - max. kW
min.- max. (Stm /h)
3
mbar
min.-max. kg/h
cSt @ 40 °C
3
kg/m
bar
kW
kW
ØValves / Connection
Ø /
Ø /
°C
°C
6
ES.
(8)
125 = DN125
HTP2000
2550 - 15300
Natural gas - Light oil
(see next paragraph)
270 - 1619
(see Note 2)
215 - 1290
2 - 7.4
840
2 max
400V 3N ~ 50Hz
37.5
37
IP40
Fully modulating
MD -
3" / DN80
4" / DN100
5" / DN125
-10 ÷ +50
-20 ÷ +60
Continuous