Unigas HTP2000 Installation Manual page 16

PART II: INSTALLATION
Matching the burner to the boiler
The burners described in this manual have been tested with combustion chambers that comply with EN676 regulation and whose
dimensions are described in the diagram . In case the burner must be coupled with boilers with a combustion chamber smaller in dia-
meter or shorter than those described in the diagram, please contact the supplier, to verify that a correct matching is possible, with
respect of the application involved. To correctly match the burner to the boiler verify the type of the blast tube (type 1 or type 2). Verify
the necessary input and the pressure in combustion chamber are included in the burner performance curve; otherwise the choice of the
burner must be revised consulting the burner manufacturer. To choose the blast tube lenght follow the instructions of the boiler manu-
facturer. In absence of these consider the following:
Cast-iron boilers, three pass flue boilers (with the first pass in the rear part): the blast tube must protrude no more than Dist = 100

mm into the combustion chamber. (please see the picture below)
Pressurised boilers with flame reversal: in this case the blast tube must penetrate Dm 50 ÷ 100 mm into combustion chamber in

respect to the tube bundle plate.(please see the picture below)
The length of the blast tubes does not always allow this requirement to be met, and thus it may be necessary to use a suitably-sized
spacer to move the burner backwards or to design a blast tube tha suites the utilisation (please, contact the manifacturer).
Fig. 6
refactory wall
Dist
ceramic fibre
Key
a) Heat output in kW
b) Lenght of the flame tube in meters
c) Flame tube firing intensity in MW/m
d) Combustion chamber diameter (m)
Fig. 6 - Firing intensity, diameter and lenght of the test flame tube as a function of the
heat input in kW.
16
Dm
ceramic fibre
refactory wall
3