Table of Contents
Advertisement
Available languages
Available languages
PRECAUTIONS
| Placement of the Unit
As the unit incorporates a powerful amplifier, heat is
radiated from the back and top of the unit; the
location where the unit is installed should be well
ventilated. Avoid installing where it would be exposed
to high temperatures, direct sunlight, high humidity
and dust.
If the wiring is too long, particularly the
speaker cables, it may result in degraded sound.
Keep
the connection cables as short as possible.
The receiver draws nominal non-operating power
from the AC outlet with its POWER switch in the
STANDBY
position.
Obs! natstrémstallaren
skiljer ej hela apparaten
fran natet.
THE APPLIANCE CONFORMS WITH EEC
DIRECTIVE 87/308/EEC REGARDING
INTERFERENCE
SUPPRESSION.
CONFORME AL D.M. 13 APRILE 1989 DIRETTIVA
CEE/87/308.
--For General Export Models
--For U.S.A:
TO THE USER
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against interference in a residential
area. This device generates and uses radio
frequency energy and if not installed and used in
accordance with the instructions, it may cause
interference to radio or TV reception.
If this unit
does cause interference with TV or radio
reception you can try to correct the interference
by one or more of the following measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation
between the
equipment and the receiver.
c) Plug the equipment into a different outlet so
that it is not on the same circuit as the
receiver.
If necessary, consult the dealer or an experienced
radio/TV technician for additional suggestions.
CAUTION
Changes or modifications to this equipment not
expressly approved by TEAC CORPORATION for
compliance could void the user's authority to
Operate this equipment.
VOLTAGE
CONVERSION
Be sure to remove the power cord from the AC
outlet before repositioning the voltage converter
switch.
1. Locate the voltage selector on the rear panel.
2. Using a flat-bladed screwdriver, set to the
appropriate 115 V or 230 V position according
to your area.
VOLTAGE
SELECTOR
15V
230V
Lo]
For CANADA
AC POWER
CORD
CONNECTION
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
r—-FOR U.S.A.
Note to CATV system installer
This reminder is provided to call the CATV
system installer's attention to Article 820-40 of
the NEC that provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the grounding
system of the building, as close to the point of
cable entry as practical.
Advertisement
Table of Contents
