Teac AG-V4200 Owner's Manual page 20

Playing Surround Sound
DOLBY 3 STEREO
DOLBY PRO LOGIC Surround
UR-407 REMOTE CONTROL UNtT IR
Un-407 REMOTE CONTROL UNT AIR
. Press the DOLBY PRO LOGIC button.
. Set the VOLUME control to the normal listening level.
. Press the CENTER MODE button to select the center
speaker mode you desire, NORMAL, WIDE or
PHANTOM mode.
. Press the TEST TONE button to send the test tone
signal to each speaker in succession as shown below.
i LEFT — CENTER — RIGHT — REAR "al
Note: If PHANTOM mode is selected in step 3, the
sound of center speaker signal is actually
output from the front (L and R) speakers.
. Adjust the CENTER LEVEL and REAR LEVEL controls
so that test tone volumes are equal on all speakers.
. Press the TEST TONE button to cease testing.
. Play the video software with the DOLBY SURROUND
mark.
. Adjust the VOLUME control for the most appropriate
overall volume.
=320=
. Press the DOLBY 3 STEREO button.
. Set the VOLUME control to the normal listening level.
. Press the CENTER MODE button to select the center
speaker mode you desire, NORMAL or WIDE mode.
. Press the TEST TONE button to send the test tone
signal to each speaker in succession as shown below.
oe — CENTER > wines
. Adjust the CENTER LEVEL controls so that the center
speaker sound level is equal to that of the left speaker
and then to that of the right speaker.
. Press the TEST TONE button to cease testing.
. Play the video software with the DOLBY SURROUND
mark.
. Adjust the VOLUME control for the most appropriate
overall volume.