Teac AG-V4200 Owner's Manual page 15

i Manual Presetting
Recalling the Preset Stations
POWER ON
POWER ON 1
1. Tune to a station by either Auto or Manual tuning.
2. Press the MEMORY button; the MEMORY indicator
will flicker in the display for approximately 5 seconds.
3. Select the channel number with the UP or DOWN
button or the numeric button(s) while the MEMORY
indicator is flickering.
When using the numeric buttons
=
iif
Lif
Ex.: Channel 1
cH
Note: After programming preset channel 1 or 2,
wait until the MEMORY indication
disappears before performing any other
function.
. Press the MODE button so that the CH indicator lights
up.
. Select the channel number of the desired preset
station with the UP or DOWN button or the numeric
button(s).
@ Scanning the Preset Stations
1. Press the MEMORY SCAN button.
2. The receiver will start scanning the stations in the
preset sequence. Each station is received for 4
seconds.
3. At the desired station, press again to stop scanning.
Ex.: Channel 20
2 0/30
@ FM MODE Button
Pressing this button alternates between Stereo
mode and Mono mode (MONO indicator lights).
Stereo
FM stereo broadcasts are received in stereo and
the STEREO indicator lights in the display.
Monophonic broadcasts are received in mono. If
FM broadcasts with weak signal strength are
received, the FM muting function works
automatically to cut the signals, eliminating
loud noise.
Mono
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced
monaural, reducing unwanted noise.
0/30 Ex.: Channel 30
4. Press the MEMORY button.
Note: When using the numeric buttons, the station is
memorized without the MEMORY button.
—45—