Teac AG-V4200 Owner's Manual page 13

AUDIO OPERATIONS
Basic Operations
1 675 4
@oo)
s <4 @
Source
component 3
POWER
SLEEP
DISPLAY
MUTING
UR-S07 REMOTE CONTROL UNIT MIR
1. Press the POWER button to ON.
Note: When using the POWER button on the remote
control unit, it should be in the standby mode.
2. Select the desired source with the source selector
buttons; then the selected source appears in the
display.
When the TAPE MONITOR button is set to ON so that
the TAPE MONITOR indicator lights up, the selected
source cannot be heard through the speakers. To
listen to a source other than the tape deck, be sure to
set the TAPE MONITOR button to OFF.
3. Operate the selected source component for playback.
4. Adjust the volume to a comfortable listening level
with the MASTER VOLUME control or VOLUME
DOWN/UP buttons.
5. Press the BALANCE button and adjust the left and
right volume balance with the MASTER VOLUME
control.
6. Press the BASS button and adjust the low frequency
level with the MASTER VOLUME control.
7. Press the TREBLE button and adjust the high
frequency level with the MASTER VOLUME control.
8. For private listening, insert the headphones (1/4-inch
plug) into the PHONES jack.
While the headphones are plugged in, sound from
the speakers is cut off.
POWER Button
You can set to ON or standby mode with this button
when keeping the POWER button on the front panel ON.
SLEEP Button
Press this button to set the receiver to automatically
turn off after 10, 20, 30, 60 or 90 minutes. Each time this
button is pressed, the sleep time changes as follows.
ee min.—20 min.—30 min.—60 min. 90min. OFF
|
DISPLAY Button
Each time the DISPLAY button is pressed, the brightness
of the display changes as follows.
ees — dim > OFF =a
In the display OFF mode, when any button is pressed,
the receiver switches to the display ON mode.
MUTING Button
When answering the telephone, etc., press the MUTING
button to temporarily silence the sound. Press again to
resume the previous volume.
= 13