Table of Contents
Advertisement
Danfoss ECtemp™ Smart
• Place the oor sensor in a protecting plastic conduit
in the oor construction in an appropriate place,
where the oor is not exposed to sunlight or draft
from door openings.
• Equally distant and >2 cm from the heating cables
on both sides.
• The conduit should
be ush with the oor
surface, countersink
the conduit if neces-
sary and possible.
• Route the conduit to
the connection box.
• The bending radius of the conduit must be min 50
mm.
Installation Guide
Note: A oor sensor is recommended in all oor
heating applications and mandatory to thin mats
under wooden oors to reduce the risk of
overheating the oor.
1
≥
2
9
Advertisement
Table of Contents
