ZyXEL Communications XMG1915 Series User Manual page 156

The following table describes the labels in this screen.
Table 69 SYSTEM > Logins
LABEL DESCRIPTION
Administrator
This is the default administrator account with the "admin" user name. You cannot change the default administrator
user name.
Old Password Type the existing system password (1234 is the default password when shipped).
New Password Enter your new system password. You can enter up to 32 printable ASCII characters.
Retype to Retype your new system password for confirmation. You can enter up to 32 printable ASCII
confirm
characters.
Edit Logins
You may configure passwords for up to four users. These users can have read-only or read/write access.
Login This is the index of an user account.
User Name Set a user name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ], or [ , ]).
Password Enter your new system password.
Retype to Retype your new system password for confirmation.
confirm
Privilege Type the privilege level for this user. At the time of writing, users may have a privilege level of 0,
3, 13, or 14 representing different configuration rights as shown below.
• 0 – Display basic system information.
• 3 – Display configuration or status.
• 13 – Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins, administrator
and enable passwords, and configuration information display.
• 14 – Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session's privilege level is greater than or equal to the
command's privilege level. The session privilege initially comes from the privilege of the login
account. For example, if the user has a privilege of 5, he or she can run commands that
requires privilege level of 5 or less but not more.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 25 Logins
XMG1915 Series User's Guide
156