KEEWAY RK V125 C User Manual page 105

Warning:
1. It is strictly forbidden to shift gears when the throttle is not returned and the clutch handle is not held tightly, otherwise it will easily
cause damage to the engine and transmission system and cause safety accidents.
2. When shifting gears, please make sure that the shift lever has been stepped on, and then release the clutch handle.
3. While the clutch handle is held tightly during gear shifting, the clutch is disengaged and the motorcycle runs by inertia. Therefore, the
shifting time should be shortened as much as possible.
4. When the gear is suddenly lowered or the throttle is suddenly returned when driving at high speed, the engine speed is lower and the
rear wheel speed is higher. When the clutch handle is released, the clutch plate frictionally engages and decelerates, causing the rear
wheel to brake, losing control and causing an accident. Therefore, the brakes must be used to slow down when changing from high-speed
driving to low-speed driving, and then lower the gear.
5. It is strictly forbidden to use the low gear to drive at high speed, and it is strictly forbidden to use the high gear to drive at low speed,
otherwise the engine will be damaged.
6. The high gear must be increased before acceleration to make the engine run within the normal speed range. No gear can make the
engine speed too high.
Note:
1. Before shifting down gears, reduce the vehicle speed or increase the engine speed. Before entering the high gear, increase the vehicle
speed or reduce the engine speed. This prevents unnecessary wear of the transmission system components and rear tires.
2. When the gear is in neutral and the neutral indicator is on, it is best to slowly loosen the clutch handle to confirm whether it really enters
the neutral position.
29
EN