Page 1
! Details described or illustrated in this booklet may differ from the vehicle's actual specification as purchased, the accessories fitted or the national-market specification. No claims will be asserted as a result of such discrepancies. Dimensions, weights, fuel consumption and performance data are quoted to the customary tolerances.
! WARNING INTRODUCTION INTRODUCTION ● Engine break-in Safety information ● Parking Please read this manual carefully and completely ● Safe-riding PERIODIC MAINTENANCE AND Welcome to the world of motorcycling! before operating this vehicle. ● Further safe-riding points ADJUSTMENT As the owner, you are benefiting from the vast experi- DESCRIPTION ●...
● This vehicle is designed to carry the operator and thoroughly familiar with the vehicle and all of its con- the result of head injuries. The use of a safety helmet SAFETY INFORMATION is the most critical factor in the prevention or reduc- a passenger.
DESCRIPTION or smell any engine exhaust. Deadly levels of carbon ● Railroad crossings, streetcar rails, iron plates on monoxide can collect rapidly and you can quickly be road construction sites,and manhole covers become Left view overcome and unable to save yourself. Also, deadly extremely slippery when wet.
INSTRUMENT AND CONTROL CONSUMER INFORMATION Meter & Indicator FUNCTIONS ● The vehicle identifi- Key Switch cation number ① is stamped on the right “ ” (Off) position: side steering head All the circuits are off. tube. ● The engine serial “...
HANDLEBAR Dimmer switch LEFT HANDLE Turn the switch to " " position, the high beam of headlamp turn on and the indicator lamp on the meter would also turn on; turn the switch to " " position, the low beam of headlamp turn on. Direction indicator lamp switch Turn the switch to "...
Front brake lever (Reserve) position ! Engine stop switch WARNING When the fuel switch is on " " (Reserve) position, Pull the brake lever properly to use the front brake. When the switch is on " " position and the power Do not over fill the fuel tank.
REAR BRAKE PEDAL PRE-OPERATION CHECKS ITEM CHECKS and road conditions. Adjust when vehicle it is stable on the main stand or side stand, turn the preload Disc brake • Check operation. Step the rear brake pedal to brake the rear wheel. Inspect your vehicle each time you use it to make ring to the place required.
OPERATION AND IMPORTANT ACCELERATION AND DECELERATION ITEM CHECKS WARNING ! RIDING POINTS The speed can be adjusted by opening and closing Wheels and tires • Check for damage. It is dangerous only to use either the front brake the throttle. To increase the speed, turn the throttle •...
PERIODIC MAINTENANCE CHART vehicle owner/operator. The most important points of range. It is strongly suggested to use the vehicle vehicle inspection, adjustment, and lubrication are very carefully during its running in period; also the ODOMETER READING ITEM CHECKS explained on the following pages. The intervals given rider has to be familiar to the performance.
CHECKING THE SPARK PLUG The spark plug is an important engine component, ODOMETER READING ITEM CHECKS which should be checked periodically, preferably by 1000Km 4000Km 7000Km 10000Km 13000Km 16000Km a dealer. Since heat and deposits will cause any Type 3 months 6 months 9 months 1 year 15 months spark plug to slowly erode, it should be removed and...
IDLE SPEED AIR FILTER 2. Start the engine, warm it up for several minutes, NOTICE and then turn it off. Good carburetion is the key of engine performance. The air filter element should be replaced and should Keep the original condition of the carburetor, as set be cleaned at the intervals specified in the periodic 3.
CHECKING THE THROTTLE CABLE CHECKING THE FRONT BRAKE LEVER AND CHECK THE DRUM LIMIT Check if braking function is excellent, and if the FREE PLAY REAR BRAKE PEDAL FREE PLAY limit index extension line is within the allowable Adjustment Nut range, as shown in Figure A.
BRAKE FLUID (IF EQUIPPED) CHECKING THE BATTERY REPLACING THE FUSES AND BULBS Meter Light 12V 2W The vehicle uses the disc brake . Adjustment is If a fuse or bulb for the individual circuits is blown, finished before delivery. Contact dealer if any prob- Horn 12V 3A Ask the dealer to add electrolyte for normal battery.
SPECIFICATION 125-26 / 150-26 dard range. Adjust the tire pressure under a "cold" 2. Lubricate drive chain. condition. 3. Drain fuel in fuel tank and carburetor out. Install the fuel tank cover again. 4. Detach the spark plug and add one teaspoon of TIRE INFORMATION (15~20cm ) clean engine oil to cylinder.