3 Place a pan under the inlet valve, then disconnect water line from the inlet
valve and drain it into a pan.
4 Disconnect drain line from pump and drain the water into a pan.
To restore service:
1 Reconnect the water, drain, and electrical power.
2 Turn on water and electrical power supply.
3 Fill the detergent cup and the rinse aid cup and run the dishwasher through
a heated-wash cycle.
4 Check all connections to make sure they do not leak.
Troubleshooting
Refer to this table to correct minor issues before calling for service.
Error codes
CODE
MEANING
E1
Longer inlet time
E4
Overflow
E8
The orientation of the distributary valve
not working.
E9
A button has been touched for more than
30 seconds (by anything, including water).
Caution
•
•
26
If an overflow occurs, turn off the main water supply before calling
for service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
POSSIBLE CAUSE
•
Faucet is not opened
•
Water intake is restricted
•
Water pressure is too low
A leak in the dishwasher
The wire is not connected correctly,
or the distributary valve is broken.
Anything (including water)
touching a button.