Troubleshooting - Hisense HVSP31 Operating Instructions Manual

Troubleshooting

Type of fault on the dis-
play
F10 Overfilling
F11 Water outlet fault
F12 Water inlet fault
F40 Inlet valve leakage
F52 Water level fault
F54 Overfilling
F56 Circulation fault
Press any button to clear the error message.
Problem
The buttons do not react
when pressed.
Action
Clear the drainage pump. See the chapter Care and
cleaning. If the problem persists, call the service
department.
See "Water remains in the dishwasher" in the table
"Problem" below. If the problem persists, call the service
department.
Check that the water tap is on. Check that the outer filter
on the inlet hose is not blocked. See Unblocking the inlet
hose filter in the chapter Care and cleaning. If the problem
persists, call the service department.
Turn off the water tap and call the service department.
Clean the coarse and fine filters. Check that the outer
filter on the inlet hose is not blocked. If the problem
persists, call the service department.
Turn off the water tap and call the service department.
Call the service department.
Possible causes
You have pressed the
buttons too soon after
opening the door.
The buttons are dirty.
The door is closed.
Action
Wait a moment then try
again.
Clean with a dry or slightly
damp cloth.
Open the door. The buttons
only react to use when the
door is open.
19