Table of Contents
Advertisement
Installing and setting up your dishwasher
1
Water supply temperature should be between 120° F and 149° F (49° C and
65° C).
Dispose of the discarded appliance and packing material properly.
2
3
The dishwasher must be grounded or it can result in a risk of electric shock.
If there is any damage of the contact to the dishwasher, please contact
4
Customer Service. Do to attempt to repair or replace any part by yourself.
For information on installing and setting up your dishwasher, refer to
the Installation Guide provided.
Before using your dishwasher
1 Remove the interior packing.
2 Clean the interior surface with lukewarm water using a soft cloth.
Finding a suitable location
•
This dishwasher is designed to be built-in.
•
The dishwasher door must be able to swing fully open.
Providing a proper power supply
Check your local power source. This dishwasher requires a 120V, 60Hz
power supply.
Refer to the Installation Guide for additional information
Understanding your dishwasher's features
How your dishwasher cleans
The dishwasher fills with water, covering the filter area at the bottom.
Water is then pumped through the various filter and spray arms, spraying a
mixture of hot water and detergent against the soiled surfaces of your
dishes and silverware. Soil particles are separated and go down the drain as the
dirty water is drained and replaced with clean water. The number of water fills
is determined by the cycle selected.
Wash cycle selections
Cycle times are approximate and will vary with options selected. Hot water is
necessary to activate dishwasher detergent and melt fatty food soils.
An automatic sensor checks the incoming water temperature and, if it is not
hot enough, the timer will be delayed to allow for the water to heat for the
main wash of all cycles. This happens even when hi-temp wash is selected,
so that higher temperature will be available to handle heavier soil loads.
7
Advertisement
Table of Contents
