Basic Operation - Hisense HDW63314SS User's Operation Manual

To cancel the delay and begin the cycle before the delay period is complete,
open the door, then press and hold Start/Cancel for three seconds.
15 - Display—Shows the remaining hours and minutes of the current cycle,
delay hours remaining, and error codes (see "Error codes" on page 26).
Notes
If the remaining time on the display suddenly increases or decreases
by several minutes, it means that the Smart Sensor has checked the
soil level or the water needs to be heated to reach the required
temperature.
16 - Start/Cancel—Press to start the dishwasher after you have selected a
cycle and function (if desired). Close the door. The cycle indicator begins to
blink and the function indicator turns on. If you don't close the door within
four seconds of pressing Start/Cancel, the dishwasher pauses.
Press Start/Cancel again to continue with the cycle.
To cancel a running cycle, open the door, then press and hold Start/Cancel
for three seconds. The dishwasher will return to standby status.
To load more dishes or pause the dishwasher while it's already running, open
the door. A safety mechanism stops the cycle.
Caution
To avoid injury open the door slowly and carefully. There is a
possibility of hot steam from inside the dishwasher.
You can add more dishes before the main wash cycle has started. To determine
this, check the detergent dispenser in the door. If the detergent dispenser is still
closed, you can add more dishes. If it is open, you can add dishes to the
dishwasher if the dish quantity is small. If the quantity is large, restart the cycle.
17 - Clean—Turns on after a cycle finished. Turns off after 1 minute when the
door is opened.
18 - Sanitize —Turns on when a sanitized cycle is finished. Turns off after
1 minute, when the door is opened.
19 - Rinse Aid—Turns on when you need to add rinse aid.

Basic operation

1 Load the dishwasher (See preparing and loading dishes).
2 Add detergent (See "Filling the detergent dispenser" on page 19).
3 Add rinse aid, if needed (See "Filling the rinse aid dispenser" on page 20).
4 Select the cycle you want (See the "Basic operation" on page 11). The
indicator will light when the selection is made.
5 Select the function you want. The indicator will light when the selection
is made.
6 To start, press S
7 Close the door within four seconds and the wash cycle will begin.
tart ancel /C on the control pad.
11