Troubleshooting - Hisense HV643D90 User's Operation Manual

Troubleshooting

Error messages
F11 Water outlet fault
F12 Water inlet fault
F13
Water level fault
F18 Diverter fault
Auto open fault
F19
F40 Inlet valve leakage
F41 Heater fault
F42 NTC fault
F54 Overfilling water
F60 Communication fault
Press to clear the error message except for F54. After the dishwasher appears F54 error, it can
only be turned off when the error is cleared.
Problem
The control panel does not react
when pressed.
Cannot close door.
24
Action
See Water remains in the dishwasher in the table Problem below.
If the problem persists, contact your nearest service centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. S e e Unblocking the inlet hose filt e r in
the chapter Care and cleaning . If the problem persists, contact
your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Contact your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Turn off the water tap. Remove the plug from the wall socket and
contact your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Turn off the water tap and contact your nearest service centre.
To avoid water leakage outside the dishwasher, do not remove
the plug from the wall socket until the water tap on the supply line
has been turned off!
Contact your nearest centre.
Possible causes
You have pressed the control
panel too soon after opening the
door.
The door is closed.
Dirt on the control panel.
The baskets are not correctly
positioned.
Action
Wait a moment then try again.
Open the door. The control
panel only reacts to use when
the door is open.
Clean with a dry or slightly
damp cloth.
Check that the baskets are cor-
rectly positioned horizontally.
Check that the dishes are not
blocking the baskets from slid-
ing properly into place.