Hisense HDW63314SS User's Operation Manual page 28

PROBLEM
Spots and filming on
dishes
Etching
Detergent left in
dispenser cup
The detergent dispenser
will not close
Water remains in the
dishwasher.
The dishwasher does
not drain properly.
Suds in the tub
The dishwasher leaks
There are black or gray
marks on the dishes
The interior of the tub
is stained
Noises
The dishwasher won't
fill (the dishwasher
will beep)
28
POSSIBLE CAUSE
Water hardness is too high
Dishes are loaded improperly.
Old or damp rinse aid power is
used.
The rinse aid dispenser is empty
or the setting is too low.
Using too much detergent.
The inlet water temperature
exceeds 150° F (65.6° C).
Detergent may be too old.
The spray arm is blocked.
Improper operation of the
detergent cover.
The previous cycle has not
finished or has been interrupted.
The drain is clogged.
The drain hose is kinked.
Using improper detergent.
Excessive suds caused by using
improper detergent.
The dishwasher is not level.
Aluminum utensils have rubbed
against the dishes.
Coffee or tea stains.
Reddish stain.
Detergent cup opening/drain
pump.
A hard object has entered the
wash module. When the object
is ground up the noise will stop.
The water valve is turned off.
The door may not be closed
completely.
POSSIBLE SOLUTION
For extremely hard water, install a water softener.
Reload the dishwasher as shown in "Preparing and
loading dishes" on page 12.
Use fresh, liquid rinse aid.
Fill the rinse aid dispenser.
Increase the rinse aid setting.
Use less detergent if you have soft water.
Lower the inlet water temperature.
Use fresh detergent.
When you load the dishes, make sure that the spray
arms are not blocked.
Add detergent and rinse aid only as indicated in this
manual. See "Filling the detergent dispenser" and "
Filling the rinse aid dispenser" on page 20.
Make sure that the current cycle is finished.
Check the air gap (if so equipped).
Make sure that the disposer is empty (if so connected).
Make sure that the drain hose is not kinked and is
properly connected.
Make sure to use only automatic dishwasher detergent.
Make sure to use only automatic dishwasher
detergent.
Level the dishwasher (refer to the Installation Manual).
Make sure that the water inlet temperature is not less
than 120° F (49° C).
Use a spot cleaner to remove the stains.
Some tomato products may cause this. Use of the
rinse only cycle right after loading will help this.
This is normal.
If the noise continues after the cycle is complete,
call for service.
Turn on the water valve.
Make sure that the door is closed and latched.