JUKI MO-2000 Series Service Manual page 31

Adjustment Procedure
Checking items:
❶ Left hand needle
❷ Upper looper
* Check that distance (projecting amount) A from the left end of left
hand needle ❶ to the blade point of upper looper ❷ is 6.8 ± 0.3 mm
when the upper looper is in its leftmost position.
How to perform adjustment:
○ Bring upper looper ❷ to its leftmost position.
○ Loosen setscrew (B) of the upper looper arm.
○ Adjust the projecting amount of the upper looper by moving upper
looper siding shaft (C) up and down.
○ Tighten setscrew (B) of the upper looper arm.
○ Turn the handwheel to check whether the rotation torque is increased.
○ Loosen screw (D). Adjust so that a clearance of 0 ± 0.15 mm (E) is
provided between the needle and the upper looper.
27
– –
Results of Improper Adjustment
If the standard adjustment value is
exceeded, stitch skipping can be
caused.