Table of Contents
Advertisement
Steps
1
Turn on, or restart your system.
2
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart
your system and try again.
3
On the System Setup Main Menu screen, click System BIOS.
4
On the System BIOS screen, click Network Settings.
Network Settings screen details
The Network Settings screen details are explained as follows:
Table 24. Network Settings
Option
PXE Device n (n = 1 to 4)
PXE Device n Settings (n = 1 to 4)
UEFI HTTP Device n Settings (n = 1 to 3)
UEFI iSCSI Settings
You can use the iSCSI Settings screen to modify iSCSI device settings. The iSCSI Settings option is available only in the UEFI boot mode.
BIOS does not control network settings in the BIOS boot mode. For the BIOS boot mode, the option ROM of the network controller
handles the network settings.
Viewing UEFI iSCSI Settings
About this task
To view the UEFI iSCSI Settings screen, perform the following steps:
Steps
1
Turn on, or restart your system.
2
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart
your system and try again.
3
On the System Setup Main Menu screen, click System BIOS.
4
On the System BIOS screen, click Network Settings.
5
On the Network Settings screen, click UEFI iSCSI Settings.
UEFI iSCSI Settings details
The UEFI iSCSI Settings screen details are explained as follows:
Description
Enables or disables the device. When enabled, a UEFI boot option is created for the device.
Enables you to control the configuration of the PXE device.
Enables or disables the UEFI HTTP device settings.
Installation and Service Manual
Pre-operating system management applications
29
Advertisement
Table of Contents
