Table of Contents
Advertisement
Joerns® Camtec Series Bed Frames
RC 750 Bed
Three Function Hand Pendant Operation
The HEAD up and down buttons cause the head of the bed to raise and lower.
The BED up and down buttons cause the height of the bed to raise and lower.
The FOOT up and down buttons cause the knees and lower portion of the legs (Knee Gatch) to
be raised and lowered.
The bed contains four electric drive modules. A hand crank is also supplied, at the head end
of the bed; which can be used to adjust the bed in the case of a power or actuator failure.
Disconnect the power before using the crank. The pendant should not be used during hand
cranking.
Adjusting the Bed Width
Caution: Extend all four sections of each side prior to adjusting bed position or
side rails.
1. Raise the bed to the highest position
2. Pull down on the blue lanyard to disengage the locking pin. A slight inward or
outward pressure on the expansion pan may be required for ease in disengaging
the locking pin.
3. Move adjustable mattress pan section about 1" in desired direction.
4. Release the blue lanyard.
5. Move adjustable mattress pan section in desired direction until locking pin snaps
into locking hole.
6. Repeat this procedure until all adjustable mattress pan sections are at the
desired locations.
Cleaning and Maintenance
Cleaning
Warning: High pressure cleaning or power wash are not to be used on any frame part.
Warning: Lock casters when cleaning, inspecting or performing any maintenance on the bed. Lower all mattress
support platform sections unless necessary for service access.
Before cleaning any portion of the bed, disconnect the power cord from the wall outlet
1. Using standard cleaning procedures, wipe down the frame of the bed. Be sure to wear appropriate protection for
the type of materials being used.
2. Use cleaning detergents sparingly around the pendant controller, electronic controller and the motors.
8
© 2016 Joerns Healthcare • 6110283 RevB • 16-2016
Advertisement
Table of Contents
