Chamberlain JDC Manual page 31

Programming (continued)
OPERATION MODE (RECOMMENDED)
To change the operating mode from the defaults B2 or C2, navigate to the SYSTEM SETTINGS > OPERATION MODE
submenu.
Operation
Mode
CONNECTIVITY (RECOMMENDED)
To connect the operator to a network, navigate to SYSTEM SETTINGS > CONNECTIVITY > LEARN > LEARN WIFI
submenu. See the "myQ® Smart Facility Access" on page 43 to connect your devices to myQ® Business Facility.
Connectivity
Hold ENTER and DOWN for three seconds to open the System Information Menu.
NOTE: This menu tree is only for informational purposes. These settings cannot be changed by the user.
Operator
1. SYSTEM
INFORMATION
HPH1
Controller Ver.
VXX.XXX.
Display Ver.
VXX.XXX.
Inverter Ver.
VXX.XX
VXX.XX
ESARM Ver.
VXX.XX
Absolute Cycles
XXXXX
Door Maint.
XXXXX Cycles
System
Monitored
Eyes/Edges
Leave
SYSTEM INFO.
Oper. Mode
C2:CNST PRES
Connectivity
C2:CNST PRES
Connectivity
C2:CNST PRES
Door Hanging
Eye/Edge 1
Oper. Mode
B2:T/TS/NO D2:CNST PRES
Oper. Mode
B2:Timer to
Learn
Remotes
Unlearn
Remotes
Door Height
Cable Drum
Mid Stop Position Type
Eye/Edge 2 Eye/Edge 3
31
Oper. Mode
E2:CNST PRES
Learn
myQ® Devices
Unlearn
myQ® Devices
Oper. Mode
Timer To Close
Oper. Mode
Learn
Remotes
Unlearn
Remotes