Table of Contents
Advertisement
7700 MultiFrame Manual
7737CE Composite Encoder with Image Enhancement
6.7.3. Setting the Detail Noise Floor
Video
Detail Enhancement
Detail Noise Floor
0 to 15
6.7.4. Setting the Enhancement Limit
Video
Detail Enhancement
Enhancement Limit
0 to 63
6.7.5. Setting the Horizontal Band
Video
Detail Enhancement
Horizontal Band
0, 5, 10, 15,
20
6.7.6. Setting the V Enhancement
Video
Detail Enhancement
Vertical Intensity
0 to 100%
6.8.
THE ON-SCREEN DISPLAY STATUS
The purpose of the Video/Audio status screen is to show as much status information about the video and
audio as possible in a small, concise table. Table 2 shows each item that may appear in the status screen.
The Status window is always displayed on the 7737CE(-A4) when not in the setup menus.
7737CE-26
When the enhanced image detail has a value that is below this floor it
will be deemed to consist mostly of noise. As such, the pixel
associated with that detail level will be left untouched (not enhanced).
Selects the largest detail value to be added back into the signal.
Detail that has a value larger than this value will be clipped.
Selects the Horizontal frequency band to be enhanced.
Where 0 selects the lowest frequency band available and 20 the
highest.
Selects the intensity of the vertical enhancement process, as a ratio of
the Horizontal enhancement.
The range is 0 to 100% in steps of 25%.
Where 0% refers to no Vertical enhancement and 100% provides a
Vertical intensity that is equivalent to the Horizontal.
Revision 1.0
Advertisement
Table of Contents
