Barco Nio Fusion 12MP User Manual page 7

1. Ambient light sensor and Power status LED
• Off: Display not powered (mains cable unplugged or power switch in OFF position),
or display is in normal operation
• Fast blinking amber: Display is entering DPMS mode
• Slow blinking amber: Display is in DPMS mode
• Steady amber: Display manually switched off via the jog dial, or display is in
hibernate mode
2. Front sensor
CAUTION: To avoid permanent damage to the product, never use the front sensor to
hold a paper, radiological film or any other object.
3. Jog dial
• Press: Activate the shortcut bar, go into (sub)menus, confirm adjustments and
selections
• Turn left/right: Scroll through (sub)menus, change values, make selections
• Press and hold for approximately 3 seconds: Cancel adjustments, exit (sub)menus
• Double-press:
- Cycle through the SoftGlow light modes (when the KVM switch is disabled)
- Switch KVM inputs (when the KVM switch is enabled)
4. Side USB-A 2.0 downstream connector
5. SoftGlow Wall light
6. SoftGlow Task light
7. Connector cover
8. VESA mount cover
9. Cable routing channels
10. Stand locking mechanism
Connectors
One USB connector is available on the side of the display. To access the bottom connectors, gently pull the
bottom of the connector cover away from the display.
Image 1–2
Welcome!
R5913350 /05 Nio Fusion 12MP 7