Table of Contents
Advertisement
Chapter 3: BIOS Setup Utility
Boot To OS/2> 64MB
Enable this item if you are booting the OS/2 operating system and
you have more than 64MB of system memory installed.
AGP Aperture Size
This item defines an AGP for the graphics. Leave this item at the
default value 64MB.
DRAM Timing
This item allows you to enable or disable the DRAM timing
defined by the Serial Presence Detect electrical.
Hyper-Threading Function
You can set "Disabled" or "Enabled" to control HT CPU support
in O.S. Set "Enabled" to test HT CPU function.
Auto detect DIMM/PCI Clock
When this item is enabled, BIOS will disable the clock signal of
free DIMM/PCI slots.
Spread Spectrum
Use this item to set the system bus spread spectrum for the
installed processor.
DRAM Driving
The default value is "Normal". If the system is unstable while
using some DDR SDRAMs, you may select "High" option.
Max CUPID Value Limit
When this item is enabled, you can use Prescott CPU and LGA-
775 CPU and there will be a normal NT4.0 installation; otherwise,
the automatically restarting will occur while installing.
29
Advertisement
Table of Contents
