Connect To The Management Ethernet Port - Cisco NCS 540 Hardware Installation Manual

Install the Device
RJ-45 Pin
8

Connect to the Management Ethernet Port

The management Ethernet port provides out-of-band management, which enables you to use the command-line
interface (CLI) to manage the router by its IP address. This port uses a 10/100/1000 Ethernet connection with
an RJ-45 interface.
Note To prevent an IP address conflict, do not connect the management Ethernet port until the initial configuration
is complete.
To connect cables to the system management port, attach Category 5 cables directly to the RJ-45 receptacle
on the management Ethernet port.
Figure 11: Console Port
Note To comply with GR-1089-CORE, the intra-building port(s) of the equipment must use shielded intra-building
cabling or wiring that is grounded at both ends.
Before you begin
You must complete initial router configuration.
Step 1 Plug the cable directly into the RJ-45 receptacle.
Step 2
Connect the network end of your RJ-45 cable to a switch, hub, repeater, or other external equipment.

Connect to the Management Ethernet Port

Signal
—
Cisco NCS 540 Router Hardware Installation Guide
29