Auto Power On By Plugin Of Ac Adaptor; I/O Interface; Figure 3-5. Jumper Selection For Auto Power On By Plugin Of Adapter; Table 3-2. Led Indicators - MEDIATEK Genio 510 User Manual

3.2.4

Auto Power On by plugin of AC Adaptor

Before using Auto Power On function by plugin of AC adaptor, the J3001 need to plug a Jumper.
Current Rating
0.1 Ampere

Figure 3-5. Jumper Selection for Auto Power on by plugin of Adapter

3.3

I/O Interface

LED Indicators
There are four LED indicators.
LED Indicators
System Power Indicator
Reset Indicator
System On Indicator
Charging Status Indicator
UART
There are three UART (UART0 、UART1 and UART2) consoles with USB to UART Bridge ICs (FT232RL) on Genio 510 EVK
board. Users can use these consoles for debug purpose. The connectors are Micro USB type.
• Supports word Lengths from 5 to 8 bits with an optional parity bit and 1 or 2 stop bits
• Supports baud rates from 110 bps up to 961,200 bps
• FTDI USB to UART Bridge FT232RL
UART Port
UART0
UART1
UART2
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
Auto Power On by plugin of AC Adaptor

Table 3-2. LED Indicators

Location Color
D1002 Green LED is on when system power in.
D3200 Green LED is on when reset key is pressed.
D1003 Green LED is on when system is on.
D1001 Red LED is on while charging.

Table 3-3. UART Ports

I/O Connector
CN3200 (Micro USB)
CN3201 (Micro USB)
CN3202 (Micro USB)
Genio 510 Evaluation Kit User Guide
Note
Purpose
Debug
Debug
Debug
Genio 510 EVK
18