Charging The Battery - Hitachi VM-E555LA Instruction Manual
Hide thumbs
Also See for VM-E555LA:
- Instruction manual (72 pages) ,
- Instruction manual (71 pages) ,
- Instruction manual (71 pages)
Table of Contents
Advertisement
The first step Is to set the battery for charging.
To charge the battery, attach if to the camcorder, and
connect the VM-ACESA AC adaptor.
Charge the battery at a temperature range of 50°F (10°C) ~ 86°F
(80°C) to prevent damage to the battery.
VM-BPL6O,
tery packs other than those specified.
CHARGE Indicator
Charge the battery on a flat surface this Is free of
vibration,
| Make sure the CAM/OFF/VCR switch is set to
OFF position.
VIDEO #|
OFF @
CAM «||
2, Attach the battery pack to the camcorder.
* Align the bottom of the battery with mark »
on the camcorder so that the battery fits into
the grooves.
Then slide the battery down-
ward, as illustrated,
| N
Mark >
Note:
Always attach a battery only by the pro-
cedure described here.
Attaching a battery
forcibly could damage ft.
3 Plug the AC adaptor power cord into an AC
outlet.
Make sure that the wide blade fits into the wide
slot.
If it doesn't fit, try reversing it. If the
blades still do not fit fully into the outlet, either
contact an electrician to replace your obsolete
outlet, or use a polarized cord or outlet access-
ory.
Connect the AC adaptor DC plug to the DC IN
jack of the camcorder.
E16
To
DCIN Jack
A
JE mb 0
To AC Outlet
Charging will start within five seconds. During
charging, the CHARGE indicator of the cam-
corder will flash or light to give you a reference
of the charged level.
Note:
If the CHARGE
indicator flashes once
every
two
seconds,
the battery
could
be
defective.
Note: The CHARGE indicator will not light at all
when the AC adaptor is defective.
Note: You can use the battery before It is com-
pletely charged.
Note:
When
charging
is complete,
the
CHARGE indicator on the camcorder will light.
IF the fully charged battery is removed and
then reattached,
the camcorder
will again
enter the charge mode, and the CHARGE indi-
cator will flash. It will take a few minutes for the
camcorder
to enter
the
charge
complete
status.
Note:
Charging
at
low
temperatures
will
decrease charge capacity,
_ After charging is complete, disconnect the AC
adaptor DC plug from the camcorder.
6 Disconnect the AC plug from the AC outlet.
7 Detach the battery from the camcorder.
Note:
Always
remove
the battery from
the
camcorder after use.
Note:
Charging is not done when the CAM/
OFF/VIDEO
switch of the camcorder
is set fo
CAM
or VIDEO.
However,
if recording pause
continues for more than 5 minutes in the CAM
mode,
the camcorder
will automatically turn
off, after which charging will start,
Note: if the DC plug Is disconnected when the
battery is attached and the CAM/OFF/VIDEO
switch is set fo CAM
or VIDEO, the camcorder
will turn off once, but Then automatically turn
on again,
Note that the battery will discharge
if the camcorder is left as is.
HITACHI
AC Adaptor
Advertisement
Table of Contents
