Table of Contents
Advertisement
CHARGING THE BATTERY PACK
1. Plug the AC
adaptor/charger
power
cord into AC
electrical outlet.
2. Attach the battery to the AC adaptor/charger.
Align
the reference arrow on the battery with that of AC
adaptor/charger and push the battery flush with the
AC adaptor/charger and slide it in the direction of
arrow.
NOTE: You must remove the DC cord from the AC
adaptor/charger to charge the battery.
If the DC
cord is connected,
charge light will flash.
3. The charge light will be lighted while the battery is
accepting a charge, and will go out when the battery
is fully charged.
Charge Light
ery,
ome very hot, is at-
"tached to the AC adaptor/ charger the "POWER"
light of the AC adaptor/charger flashes.
In. this
Ber boris ate :
to the AC adaptor/ charger is not recomme| ded: :
it should be allowed to cool down before being at-
tached.
r
NOTES:
ie
capa C ity 'will:be teduced even if it is left unused.
Be sure to. charge before: using it.
° When 'the: cameta/recorder is -turnéd on, the
capacity 'of 'the battery: pack will: be.reduced even
if the camera/recorder is not recording. Turn off
the camera/recorder when not using it.
If the record pause mode is: used too often or the
battery.is used at-low temperatures, the time for
which 'the battery can be used will be shortened.
@ Insertion
1. Slide EJECT
switch and insert the cassette so the
transparent
window
is toward
you and the arrow
toward the cassette holder.
Slide the cassette into
cassette holder as far as it will go.
NOTE:
If the power
source
is not connected
to
camera/recorder, the cassette holder will not open.
m Removal
1. Slide EJECT switch and remove the cassette.
ma
EJECT Switch
Cassette
Holder
17
Advertisement
Table of Contents
