Connecting To A Television Without - Hitachi VM-E555LA Instruction Manual

Connecting to a Television without Audio In and Video In Jacks
UHF Antenna VHE Antenna
-—UHFIIN— ag IN-
75-ohm |
L j
peee
RF Converter Unit (optional)
RF Channel Select Switch
1 Disconnect the VHF antenna leads from the
back of the television. Leave the UHF antenna
leads connected.
2 Connect the VHF antenna lead to ANT IN of the
RF converter unit. If the cable on the VHF
antenna lead is flat you need to purchase an
antenna adaptor (300-ohm to 75-ohm trans-
former). Connect the antenna adaptor to the
VHF antenna lead and slide the adaptor on to
the ANT IN terminal.
3 Connect the 75-ohm coaxial cable of the RF con-
verter unit to the VHF antenna terminals on the
back of the television. If the television is set up
to connect to a flat antenna lead you need to
purchase an antenna adaptor (75-ohm to 300-
ohm transformer). Connect the adaptor to the
75-ohm coaxial cable of the RF converter unit
and connect the free ends of the adaptor to the
VHF antenna terminals at the back of you tele-
vision.
E38
Camcorder
To Audio/Video
Output Jack
© Antenna Adaptor
(300-ohm to 75-ohm)
(not supplied, consult
your nearest dealer
if you need this.)
4 Connect the RF converter unit cable to the
Audio/Video Output jack of your camcorder.
Turn your television on and select channel 3
(channel 4, if channel 3 is a channel used in your
area).
Select the CH3 or CH4 on the RF converter unit
matching the channel selected on your tele-
vision.
Insert the previously recorded cassette into the
camcorder.
8 Hold down the red button on the CAM/
OFF/VIDEO switch while sliding the switch to
VIDEO.
9 Press the PLAY button to begin playback.
10 Press the STOP button when finished.
Note: The RF converter unit cannot be used
during multi playback (PAL60 output).
HITACHI