Advertisement
Oct-21
6. STORAGE
This Borum jack should always be stored in a dry location on a level surface with the lift ram
pistons in the fully retracted position, where it will not be exposed to corrosive vapours, abrasive
dust, or any other harmful elements.
7. MAINTENANCE
Monthly maintenance is recommended. Lubrication is critical to jacks as they support heavy loads.
Any restriction due to dirt, rust, etc, can cause either slow movement or cause extremely rapid
jerks damaging the internal components. The following steps are designed to keep the jack well
maintained and operational.
Important: Dirt is the greatest single cause of failure in hydraulic units. Keep the jack clean and
well lubricated to prevent foreign matter from entering the system. If the jack has been exposed
to rain, snow, sand, or grit it must be cleaned before it is stored or used.
• Only use replacement parts that are approved by the manufacturer. Disconnect the air supply
before performing any maintenance operation.
• Lubricate the ram, linkages, saddle, wheels and pump mechanism with light Hydraulic oil.
• Visually inspect for cracked welds, bent, loose, missing parts or hydraulic oil leaks.
• Any hydraulic jack found to be damaged, worn or operates abnormally must be removed from
service until repaired by an authorised service representative.
• Regularly clean all surfaces and maintain all labels and warnings.
• Check and maintain the hydraulic ram oil level.
• Check the ram every three months for any sign of rust or corrosion. Clean as needed and wipe
with a clean oily cloth. When not in use always leave the saddle and ram all the way down.
• Always store your jack in the fully retracted position. This will help protect critical areas from
corrosion. Do not use brake or transmission fluids or regular motor oil as they can damage the
seals.
ONLY USE HIGH QUALITY HYDRAULIC FLUID – ISO68
8. SERVICE & REPAIR
Any Borum jack found damaged in any way, or found to be worn or operates abnormally should be
removed from service until repaired by an authorised service agent. Owners and / or operators
should be aware that repair of this product may require specialised equipment and knowledge. Only
authorised parts, labels, decals shall be used on this equipment. Annual inspection of the jack is
recommended and can be made by an authorised repair facility to ensure that your equipment is in
optimum condition and that the equipment has the correct decals and safety labels specified by the
manufacturer.
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
BTJ1530TA
P a g e
| 6
Advertisement
