Advertisement
Oct-21
3. BEFORE USE
Prior to each use conduct a visual inspection checking for abnormal conditions, such as cracked
welds, leaks, and damaged, loose, or missing parts.
• Consult the vehicle owner's manual to determine the location of lift points.
• Be sure to set the vehicle in park with the emergency brake on and wheels securely chocked.
• Be sure that the vehicle and the jack are on a hard, level surface.
4. OPERATION
1. This jack is equipped with a handle position lock. To adjust the handle, release the lock device by
pulling the lever up. The lever is spring loaded so, so it should lock into the desired position.
2. Make sure the jack and load are on a hard level surface.
3. Always set the vehicle parking brake and block the wheels.
4. Check the placement of the jack. The load must be centered on the jack saddle. Avoid jack wheel
obstructions such as gravel, tools, or uneven expansion joints.
5. Position the jack under the load using the manufacturer's recommended lifting points on the
chassis.
6. Connect compressed air supply to the jack. (Compressed air should be clean, dry, and regulated
at 120-170psi). Install an air filter/lubricator in the workshop air-line, because water in the airline
will damage the jack.
7. Rotate the lever RIGHT to the UP position. (To stop air operation, simply release the grip on the
lift control trigger). Continue to pump the jack until the head cap reaches the load.
8. Before raising the load, double check and verify the saddle is centred and has full contact with
the specified lifting point.
9. Rotate the lever RIGHT to the UP position (To stop air operation, simply release the grip on the
lift control trigger). Continue to pump the jack to lift the load to the desired height.
10. Always immediately position approved support stands under the load at points that will provide
stable support in accordance with the vehicle or load manufactures recommendations.
11. Always lower the load slowly onto the support stands by rotating the lever LEFT to the DOWN
position.
12. Carefully lower the load onto the support stands by rotating the lever to the DOWN position
Lowering the Load
1. Raise the load by following Steps 2-9
2. Raise the load high enough to allow clearance for the support stands to be removed by rotating
the lever to the Right UP position.
3. Carefully remove the support stands
4. Grasp the jack handle firmly. Securely hold onto the jack handle so that your hands do not slip
and ensure the release valve does not lower rapidly.
5. Carefully open the release valve by slowly rotating the LEVER to the LEFT DOWN position.
6. Once the load has been lowered, remove the jack from beneath the load, and fully retract the
ram to prevent exposure to dirt and grime.
5. INSPECTION
• Prior to each use conduct a visual inspection checking for abnormal conditions, such as cracked
welds, leaks, and damaged, loose, or missing parts.
• The jack shall always be maintained in accordance with the maintenance instructions (Section 7).
No alterations or modifications shall be made to this Jack.
• Inspections shall be performed in accordance with this owner's manual.
• The jack must be inspected immediately if it is believed to have been subjected to abnormal load
or shock.
• Owners and /or operators should be aware that repair of this product may require specialised
equipment and knowledge (refer to maintenance section).
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
BTJ1530TA
P a g e
| 5
Advertisement
