Tarmo XTP120 Instruction Manual page 78

Loss of traction drive
Loss of snow discharge
or slowing of snow
discharge
Discharge chute either
does not lock into place
or does not move
Machine does not
properly clear the snow
of the surface
1. Drive control cable not
adjusted properly.
2. Drive belt loose or damaged.
3. Friction wheel worn.
1. Discharge chute clogged.
2. Augers or impeller jammed.
3. Auger control cable not
adjusted properly.
4. Auger belt loose or damaged.
5. Shear pin(s) sheared.
6. Throttle not in FAST position
when blowing snow.
7. Moving too fast to clear the
snow.
8. Blowing too much snow.
9. Trying to remove extremely
heavy or wet snow.
10. Auger is frozen in place.
1. The discharge chute control not
adjusted properly.
2. Chute assembly incorrectly.
1. The skid shoes and/or scraper
not adjusted properly.
2. The pressure in the tires not
equal.
1. Adjust drive control cable.
2. Replace drive belt.
3. Replace friction wheel.
1. Unclog discharge chute.
2. Remove debris or foreign object
from augers or impeller.
3. Adjust drive control cable.
4. Replace auger belt.
5. Replace with new shear pin(s).
6. Move throttle to FAST position.
7. Shift into a lower gear.
8. Reduce speed and width of swath.
9. Do not overload with extremely
heavy or wet snow.
10. Move unit to a warm place to
thaw.
1. Adjust the discharge chute control.
2. Disassemble chute control and
reassemble as instructed in this
manual.
1. Adjust the skid shoes and/or the
scraper.
2. Check and adjust the pressure in
one or both tires.
78