Tarmo XTP120 Instruction Manual page 73

forward so that in rests on the auger housing.
5. Remove the frame cover from the underside
of the snow blower by removing the screws
which secure the cover.
6. Remove the belt(s) from around the auger
pulley, and slip the belt(s) between the support
bracket and the auger pulley.
7. Replace the auger belt(s) by following
instructions in reverse order.
Drive Belt
If the drive belt becomes worn, oil-soaked, or
otherwise damaged, proceed as follows to replace
the belt.
1. To prevent spillage, remove all fuel from tank
by running engine until it stops. Remove the
key to avoid unintended starting and allow unit
to cool completely.
2. Remove the two screws that hold the belt
cover in place and set the cover aside.
3. Remove the belt as follows.
a. Roll the auger belt off the engine pulley.
b. Pivot the idler pulley toward the right to
relieve tension.
c. Lift the drive belt off engine pulley.
4. Carefully pivot the snow blower up and
forward so that it rests on the auger housing.
5. Remove the frame cover from the underside
of the snow blower by removing the screws
which secure the cover.
6. Slip the drive belt off the pulley and between
friction wheel and friction wheel disc.
7. Remove and replace belt in the reverse order.
73